DIY Christmas Tree Ornaments

Start a new tradition by making tree ornaments out of recycled and repurposed materials.

By Plenty staff

Instead of store-bought trimmings for our office Christmas tree, the Plenty editors (along with a few crafty friends and family members) made ornaments entirely from found or recycled objects—no buying or using anything new. The resulting decorations were fresh, festive, and — if we do say so ourselves — surprisingly good. Here are a few standouts.


Tin Can Star


* Three 42 oz aluminium cans

* Aluminum take-out food containers

-  Clean and dry cans. Then, carefully cut off each can’s top and bottom and uncurl the remaining piece of aluminum, flattening overnight under a heavy book if necessary.

- Make basic origami stars using flattened aluminum instead of paper (just be careful of the sharp edges). You can view an animated diagram of the pattern and folding technique at

-  Use one of the flattened 42 oz cans to make the biggest origami star. Use the aluminum take-out containers to make stars that get gradually smaller as you layer them. I used three stars for stacking.

-  Use another 42 oz can to cut out the flat base star.

-  Coil the third flattened can into a cone shape. Use a dab of nontoxic glue to seal the overlapping edges.

-  Hold the smallest origami star with its center point facing away from you. Place a dab of glue inside the point. Put the next biggest star inside the smaller star, glue next center point and attach a slightly smaller star, and repeat, working toward the smallest star.

-  Place the stacked stars on the base star. Add dots of glue where stackers touch the base star's surface. Make rays from thin strips of tin. Glue these to the back of the base star.

-  Carefully place star on tin cone, using a tiny dab of glue. Tin cans come in every conceivable color and pattern—have fun mixing it up.

Bottle-Cap-and-Ribbon Bows


* Photos or magazines

* Bottle caps

* Nontoxic glue

* Leftover scraps of gift-wrapping ribbon, various lengths and widths

-  Cut an image to fit the size of the bottle-cap interior and glue it in, pressing to make sure the image lies flat.

-  Take one of the wider ribbons and tie it into a bow proportional to the size of the bottle cap.

-  Then, take a thinner ribbon, preferably one with wire in it for stiffness, and thread it through the top of the bow’s knotted center. Once threaded, pull ribbon to desired length and tie a knot at the top to form a loop.

-  Glue the back of the bottle cap to the bow.



* Coffee can lid

* Shells

* Nontoxic glue

* Raffia (or yarn)

-  Cut out the inside of coffee can lid to use as wreath base.

-  Wrap raffia around the lid and tie in back to make a loop.

-  Glue cut shells and smaller seashells onto raffia.

-  Glue on raffia for hook to hang.

Gingerbread Man


* A piece of sandpaper

* A used brown paper bag

* Thread

* Large handful of dryer lint

* String

* Scraps of used ribbon

* Mismatched buttons

* Scrap of old fabric

-  Using sandpaper, lightly sand the surface of the paper bag until it has a soft, felt-like texture.

-  Cut two identical gingerbread man shapes out of the paper. Sew together with thread, using large stitches, ⅛ inch away from the edge, stuffing the dryer lint into the arms and legs as you go.

- Once you have fully stuffed and sewn up the gingerbread man, make a hole at the top of the ornament and thread a piece of string or ribbon through. Knot at the top to form a hanging loop.

-  Glue the buttons down the front of the ornament and draw a face with a pen. Cut a thin strip of fabric from the scrap to tie on as a scarf.